RUM/CZK - Praga V (subvencovaný nákladní automobil 4x2)

Praga V
     
Název:
Name:
Praga V Praga V
Originální název:
Original Name:
Praga V
Kategorie:
Category:
valník cargo bed truck
Výrobce:
Producer:
ČKD, Praha /

První českomoravská továrna na stroje (automobilní oddělení Praga)
Období výroby:
Production Period:
DD.MM.1911-DD.MM.1922
Vyrobeno kusů:
Number of Produced:
1294
Prototyp vyroben:
Prototype Built:
před 11.10.1911 (tři prototypy)
Počet míst k sezení:
Troop Seating Capacity:
1 + 1
Technické údaje:
Technical Data:
 
Náhon:
Configuration:
4x2
Pohotovostní hmotnost:
Curb Weight:
3500 kg 7716 lb
Užitečné zatížení:
Payload:
5000 kg 11023 lb
Celková hmotnost:
Gross Vehicle Weight:
8500 kg 18739 lb
Přípojná hmotnost:
Gross Trailer Weight:
3000 kg 6614 lb
Celková hmotnost s přívěsem/návěsem:
Gross Combination Weight:
11500 kg 25353 lb
Celková délka:
Overall Length:
6200 mm 20ft 4in
Celková šířka:
Overall Width:
2000 mm 6ft 7in
Celková výška:
Overall Height:
2600 mm 8ft 6in
Světlá výška:
Ground Clearance:
? mm ?
Rozvor:
Wheelbase:
4000 mm 157 ½ in
Rozchod:
Track:
1500 mm - přední náprava
1360 mm - zadní nápravy
59in - front axle
53 ½ in - rear axle
Brzdová soustava:
Braking System:
? ?
Elektrický systém:
Electrical System:
? ?
Pneumatiky:
Tyres:
přední jednoduché, plnopryžové: Ø820x120 mm,
zadní zdvojené, plnopryžové: Ø1050x140 mm.
Pohon:
Propulsion:
 
Typ:
Type:
Praga (zážehový, řadový, vodou chlazený čtyřválec s obsahem 6.839 cm3, výkon 40 k při 800 1/min) Praga (gasoline, inline, water cooled four-cylinder with 6.839 ccm, power 40 HP at 800 rpm)
Převodovka:
Gearbox:
? ?
Spojka:
Clutch:
? ?
Objem palivových nádrží:
Fuel Tank Capacity:
160 l 35.2 Imp gal
Výkony:
Performance:
 
Rychlost na silnici:
Road Speed:
16 až 22 km/h 10 to 14 mph
Rychlost v terénu:
Cross-country Speed:
? km/h ? mph
Spotřeba paliva:
Fuel Consumption:
? l/100 km ? mi/Imp gal
Jízdní dosah po silnici:
Cruising Range on Road:
? km ? mi
Jízdní dosah v terénu:
Cross-country Cruising Range:
? km ? mi
Překonávání překážek:
Obstacles Crossing:
 
Nájezdový úhel přední/zadní:
Angle of Approach/Departure:
? ° / ? °
Svah:
Gradient:
? ° ? %
Boční náklon:
Side Slope:
? ° ? %
Překročivost:
Trench Crossing:
? m ?
Výstupnost:
Vertical Obstacle:
? m ?
Brodivost:
Fording Depth:
? m ?
Uživatelské státy:
User States:














Poznámka:
Note:
Disky zadních kol byly opatřeny navijákovými bubny. K vyprošťování se používala dvě ocelová lana o délce 15 m.
Součástí dodávané soupravy byl jeden přívěs Praga P s únosností 3 tuny.
The rear wheels were equipped with reel drums. Two steel ropes with a length of 16,4 yd were used for recovery.
One Praga P trailer with a capacity of 3 tonnes was included in the set.
Zdroje:
Sources:
autor neuveden: Merkbuch der mit Autozug befördern Geschütze und der K.u.K. schweren Artillerie in Verwendung stehenden Autotypen, Kriegsministerium, Wien 1918, ISBN nemá
Emil Příhoda: Praga - Devadesát let výroby automobilů, nakl. Unium, Praha 1998, ISBN 80-902542-1-7
Jan Králík: Praga V - Státní subvencovaný autovlak, in DB Schenker, Zpravodaj 2002, č.1, ISSN nemá
URL : https://www.valka.cz/RUM-CZK-Praga-V-subvencovany-nakladni-automobil-4x2-t209429#591748 Version : 0
Brief history
The Austro-Hungarian military administration found its fleet insufficiently equipped with vehicles of 3 ton capacity. In early 1911, a competition for the design of a car train was announced. The first Czech-Moravian engineering company entered a product of its car factory into the competition. The chief designer was František Kec, who joined Pragovka on 1 April 1911 and immediately started work on the military car project. He drew up designs, which the designers traced in detail. The twenty-eight year old enthusiastic young man negotiated with modellers, founders, blacksmiths, ran from devil to devil, introduced new working methods. The factory produced parts for the construction of three cars - two were assembled and the third remained in parts as a reserve. From the young designer's arrival at the factory to the realization 194 days passed. The factory was not enthusiastic about the cars, because the condition was a kerb weight of only 3 t. The chief designer Kec did not meet the requirement, because after the vehicles were assembled and transported, the Praga V turned out to weigh 3.5 tonnes. This upset Director Havranek, who feared that the vehicles would not be admitted to the competition. Therefore, chief designer Kec was sent to Vienna with the vehicles to enjoy the possible embarrassment on the spot. The two Prags made the journey to Vienna on 11 October. 13 vehicles arrived for test drives, including two Prags. There was no weight overrun shame, as apart from the Swiss Berna, most of the vehicles reached or exceeded 4 tonnes. And then when one of the Pragovkas loaded 5 tons instead of the prescribed 3 tons, the faces of the representatives of the other brands were stretched.


Another advantage was given to the Praha vehicles by an incident at the beginning of the competition, when a column of tested vehicles arrived at a semi-dry riverbed, which all the cars had to cross. The vehicles driving in front of the Prags got stuck in the middle of the river in the mud. The two Prags were the last to reach the river, and Kec had the loaded trailers disconnected from their cars and sent the cars alone into the riverbed. The moment their wheels began to spin and dig in, the drivers were told to stop. The recovery ropes were then extended and secured, and with their help the two Prag cars drove to the other bank. The loaded trailers and finally the competitors' cars were then pulled over.


After the test runs of the 7th Lithopad were completed, the technical design of the Praga vehicles was duly appreciated when the Austro-Hungarian Army ordered the first 18 vehicles with trailers. The company's success in the competition also persuaded the representative of the Hungarian Wagon Factory in Rab to purchase a licence. The purchase price of the vehicle with trailer was K16,500 and the army paid 50% of the price to the buyer. By the end of the year Praga Automobilka managed to produce and deliver vehicles to the civil sector, e.g. to a. s. Pražské mlýny and Waldes & spol.


Note
Text taken with the kind permission of the author.


Source
Jan Králík: Praga V - State subsidized bus train, in DB Schenker, Newsletter 2002, No.1, ISSN does not
RUM/CZK - Praga V (subvencovaný nákladní automobil 4x2) - Praga V s přívěsem Praga P.

Praga V s přívěsem Praga P.
RUM/CZK - Praga V (subvencovaný nákladní automobil 4x2) - Via Merkbuch ...

Via Merkbuch ...
RUM/CZK - Praga V (subvencovaný nákladní automobil 4x2) - Chassis Praga V - via internet.

Chassis Praga V - via internet.
URL : https://www.valka.cz/RUM-CZK-Praga-V-subvencovany-nakladni-automobil-4x2-t209429#591749 Version : 0
Discussion post Fact post
Attachments


Join us

We believe that there are people with different interests and experiences who could contribute their knowledge and ideas. If you love military history and have experience in historical research, writing articles, editing text, moderating, creating images, graphics or videos, or simply have a desire to contribute to our unique system, you can join us and help us create content that will be interesting and beneficial to other readers.

Find out more