Kit vehicle charger RF 10 - N1 is designed for accelerated charging one source cabinets full QN 732 10 from the radio station RF-10. The kit is designed for fixed installation in mobile vehicles, especially combat vehicles of infantry and armored vehicles.
Because the kit vehicle charger is not equipped with a device for controlling the voltage source cabinets (PKN), doesn't operate virtually no information about the status of the source cabinet before charging and after charging. To avoid unnecessary shortening of the lifetime of the source cabinets, it is recommended to use the vehicle charger only in combat.
The main tactical - technical data
Kit vehicle charger RF 10 - N1 meets the following technical data:
Power supply: from dc on-board network 26, In with max. fluctuations from 20 to 30 In
Sampling of the on-board network: 3.2 And
Charging current: 3 And ss +- 0.15 And ss
Charging time: 60 min. + 3min., -6 min.
The number of connected source cabinets: 1 pcs
Indication: Charging indicates a green lamp on the panel of the charger.
The indication must be: a) for open or shorted to the source closet
b) in the source closet, which when the charge reaches the min. 4.5 V
Traffic: Vehicle charger is protected against damage during incorrect handling, in particular
- against the incorrect polarity of the connected source cabinets
- against short circuits at the output of the
- against wrong polarity of the supply voltage
- against short-circuit inside the unit (protection of the on-board network)
- in the off state draws no current from the on-board network
Operating temperature: the operating temperature range is -35°C to +50°C
Dimensions charger unit: 310 x 160 x 100 mm (without hinge)
The weight of the charger: 3.5 kg
The weight of the set: 7.5 kg
The median time between the two disorders is min. 5000 hours.
Source: the Manual.
Because the kit vehicle charger is not equipped with a device for controlling the voltage source cabinets (PKN), doesn't operate virtually no information about the status of the source cabinet before charging and after charging. To avoid unnecessary shortening of the lifetime of the source cabinets, it is recommended to use the vehicle charger only in combat.
The main tactical - technical data
Kit vehicle charger RF 10 - N1 meets the following technical data:
Power supply: from dc on-board network 26, In with max. fluctuations from 20 to 30 In
Sampling of the on-board network: 3.2 And
Charging current: 3 And ss +- 0.15 And ss
Charging time: 60 min. + 3min., -6 min.
The number of connected source cabinets: 1 pcs
Indication: Charging indicates a green lamp on the panel of the charger.
The indication must be: a) for open or shorted to the source closet
b) in the source closet, which when the charge reaches the min. 4.5 V
Traffic: Vehicle charger is protected against damage during incorrect handling, in particular
- against the incorrect polarity of the connected source cabinets
- against short circuits at the output of the
- against wrong polarity of the supply voltage
- against short-circuit inside the unit (protection of the on-board network)
- in the off state draws no current from the on-board network
Operating temperature: the operating temperature range is -35°C to +50°C
Dimensions charger unit: 310 x 160 x 100 mm (without hinge)
The weight of the charger: 3.5 kg
The weight of the set: 7.5 kg
The median time between the two disorders is min. 5000 hours.
Source: the Manual.